Re: How to implemet table

There is no comments available in the code to know where to put my code. can
you tell me if I have to put my object vales where I need to write te code
and to which variables I need to assign values.

Vishal N

On Thu, Feb 21, 2008 at 2:51 PM, Dave Shield <[email protected]>
wrote:

> On 21/02/2008, Vishal N <[email protected]> wrote:
> > I want to implement tables in the agent. Can any one tell me which
> config
> > file I should use to generate code using mib2c?
>
> Please see the FAQ entry
>    Which mib2c configuration file should I use?
>        http://www.net-snmp.org/wiki/index.php/FAQ:Coding_08
>
> the "mib2c General Overview" tutorial page
>    http://www.net-snmp.org/wiki/index.php/TUT:mib2c_General_Overview
>
> or run "mib2c" without specifying a config file, and answer
> the prompts that it will give you.
>
>
> > is it mib2c.table.conf or mib2c.array_user.conf?
>
> Neither of these config templates exist.
> See the directory 'local' for the choices open to you.
>
> Personally, I tend to work with the 'mib2c.table_data.conf'
> template (which uses the tdata helper).   I know Robert prefers
> the 'mib2c.mfd.conf' template, which uses a completely different
> framework.
>   But either of these (or any of the others) should provide
> a reasonable starting point.  There's no One Right Answer.
>
>
> Dave
>

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users