Timeout:No Response From 127.0.0.1

root@simone-laptop:/usr/share/snmp# ps -ef | grep snmp
root 6696 6088 0 10:45 pts/0 00:00:00 grep snmp

here is my snmpd.conf:

###########################################################################
#
# snmpd.conf
#
# - created by the snmpconf configuration program
#
###########################################################################
# SECTION: Trap Destinations
#
# Here we define who the agent will send traps to.

# trapsink: A SNMPv1 trap receiver
# arguments: host [community] [portnum]

trapsink localhost

# trap2sink: A SNMPv2c trap receiver
# arguments: host [community] [portnum]

trap2sink localhost

# informsink: A SNMPv2c inform (acknowledged trap) receiver
# arguments: host [community] [portnum]

informsink localhost

# trapcommunity: Default trap sink community to use
# arguments: community-string

trapcommunity public

# authtrapenable: Should we send traps when authentication failures occur
# arguments: 1 | 2 (1 = yes, 2 = no)

authtrapenable 1



###########################################################################
# SECTION: System Information Setup
#
# This section defines some of the information reported in
# the "system" mib group in the mibII tree.

# syslocation: The [typically physical] location of the system.
# Note that setting this value here means that when trying to
# perform an snmp SET operation to the sysLocation.0 variable will make
# the agent return the "notWritable" error code. IE, including
# this token in the snmpd.conf file will disable write access to
# the variable.
# arguments: location_string

syslocation notebook

# syscontact: The contact information for the administrator
# Note that setting this value here means that when trying to
# perform an snmp SET operation to the sysContact.0 variable will make
# the agent return the "notWritable" error code. IE, including
# this token in the snmpd.conf file will disable write access to
# the variable.
# arguments: contact_string

syscontact simone



###########################################################################
# SECTION: Access Control Setup
#
# This section defines who is allowed to talk to your running
# snmp agent.

# rocommunity: a SNMPv1/SNMPv2c read-only access community name
# arguments: community [default|hostname|network/bits] [oid]

rocommunity public









###########################################################################
# SECTION: Agent Operating Mode
#
# This section defines how the agent will operate when it
# is running.

# agentaddress: The IP address and port number that the agent will listen
on.
# By default the agent listens to any and all traffic from any
# interface on the default SNMP port (161). This allows you to
# specify which address, interface, transport type and port(s) that you
# want the agent to listen on. Multiple definitions of this token
# are concatenated together (using ':'s).
# arguments: [transport:]port[@interface/address],...

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users