Re: how to modify the output of an smpset command
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 12/03/2008, Jordi Moles <[email protected]> wrote: > i'm using perl to extend the functionality of snmp. Extending the agent, I presume. > The thing is that if i run this command: > > ******** > snmpset -v 2c -c mykey localhost .1.3.6.1.4.1.2021.255.8.1.9 s > "delete...bustia01" > ******** > i get this in the shell....... > > ******** > UCD-SNMP-MIB::ucdavis.255.8.1.2 = STRING: "delete...bustia01" > ******** That's correct. The specification of SNMP states that the response to a SET request will contain the exact same set of varbinds. > so... what i would like to do is replacing this "STRING: > "delete...bustia01" witch something else dynamically Sorry - SNMP doesn't work that way. The response will include the same value as was SET. You can't change that. Dave ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users