Re: receive a trap
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 12/03/2008, snmp girl <[email protected]> wrote: > I try snmpTrapAddr udp:hostname:162 > with hostname: 192.168.192.120 > but It gives me that snmptrapaddr no known as a cmd I believe that Mike was suggesting this as a configuration directive, rather than a DOS command. Personally, I'd tend to specify this on the command line directly: snmptrapd -f -Le udp:192.168.192.120:162 But you will still need to create the snmptrapd.conf file, to set the trap access control stuff. > ah another question should I create the snmpd.conf file or not Are you going to be working with the Net-SNMP agent, or just the trap receiver? snmpd.conf is used with the agent. snmptrapd.conf is used with the trap receiver. I would tend to suggest that you concentrate on one at a time. Get the trap receiver working first, and *then* worry about the agent. Dave ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users