Fwd: receive a trap

2008/3/12, Dave Shield <[email protected]>:
>
> On 12/03/2008, snmp girl <[email protected]> wrote:
> > I try snmpTrapAddr udp:hostname:162
> > with hostname: 192.168.192.120
> > but It gives me that snmptrapaddr no known as a cmd
>
> I believe that Mike was suggesting this as a configuration
> directive, rather than a DOS command.
>   Personally,  I'd tend to specify this on the command
> line directly:
>
>    snmptrapd -f -Le  udp:192.168.192.120:162
>
>
> But you will still need to create the snmptrapd.conf
> file, to set the trap access control stuff.
>
>
>
>
> > ah another question should I create the snmpd.conf file or not
>
> Are you going to be working with the Net-SNMP agent,
> or just the trap receiver?    snmpd.conf is used with the agent.
> snmptrapd.conf is used with the trap receiver.


just the trap receiver because the agent I have already configure it in a
linux machine .
so as I see , I should create the snmpd.conf in the /etc/snmp and write in "

disableAuthorization yes"

that's it???

I would tend to suggest that you concentrate on one at a time.
> Get the trap receiver working first, and *then* worry about
> the agent.
>
> Dave
>

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users