Re: Regarding Table data Create and Fill
Stéphane Champeau <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Dave, I'm agree with you but : - the template code is a little buggy - the 'load' routine isn't call when the table is empty. After the 'init' function if the table is empty the 'load' function is *never* call (see my post "Cache helper wasn't call when the table is empty") Stephane. Dave Shield a écrit : On 14/03/2008, kumar undurthi <[email protected]> wrote: I have requirement in which i have to fill the table data when ever a request will come,.... when the a request come at " i.e "(check in code ) case MODE_GET:" then i want to update the table And as I said last week, the best way to do this is to use the cache helper. Generate the template code using mib2c -c mib2c.table_data.conf -S cache=1 ocStbHostAVInterfaceTable and put the code for updating the table into the 'load' routine. Dave ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users