Tables on agentx

Hello,
I'm new in snmp development.

I want to use an agentx on some nodes (pc) and make it communicate
over tcp with a master agent on one other.

I have the same data on each node, like number of disks, capacity, the
status of a dynamic set of services, etc.

The same mib is installed on all nodes. I think the correct way is to
use tables.

I create the table in the mib and create the generic code with mib2c;
what is the structure of the code generated by mib2c when I use
mib2c.mfd.conf?

What is the difference between container and cache?

Thank you


-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users