sending V3 traps with trapsess
"Josh Bers" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Organization | BBN Technologies |
| Message-ID | <007b01c894e3$fc536530$71fe5980@7C911> |
I am seeing strange behavior when configuring snmpd to send traps using trapsess command in the snmpd.conf file. When I don't specify an engineID explicitly it attempts to do discovery even though I am not asking for INFORMS! I would expect the code to use the authoritative engine ID of the snmpd agent unless otherwise specified. If I try explicitly using the oldEngineID that I find under /var/net-snmp/snmpd.conf my manager complains that the timeline info is wrong in the trap that it received. How can I configure snmpd to send v3 authPriv TRAPS to a manager? I am using version 5.1.2. Does anyone know if this has been fixed on later versions? Thanks, Josh Josh Bers Senior Engineer, Mobile Networking Systems BBN Technologies web: www.bbn.com ph: (617) 873-4262 fax: (617) 873-4523 ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users