questions about snmpd.conf

Hi,
   I have a question about snmpd.conf. You know we can use "view" to 
configurate which 
row we can access with "MASK", but how to configurate which column to 
access? Only we
can do is adding the OID of the table's column to view one by one? 

for example:
In table "ifTable", I only want to access several columns such as ifIndex, 
ifMtu, and ifSpeed ...
now we must add following lines in snmpd.conf:

view sysview include ifIndex
view sysview include ifMtu
view sysview include ifSpeed
......

Is there any more effective way to configure like using "MASK" to access 
rows of table?

Thanks a lot!

Best Regards,

Song Hao(郝松)

--------------------------------------------------
Meter System Division
ShenZhen KaiFa Technology Co., Ltd.
Office Tel. ：(86 755) 8327 5000 (Main) Ext. 36302
Fax         :(86 755) 8327 5061
--------------------------------------------------



This message has been scanned.
(210.245.235.14)

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft 
Defy all challenges. Microsoft(R) Visual Studio 2008. 
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users