Re: about snmpd configuration
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
2008/5/27 <[email protected]>: > I create a v3 user in /var/net-snmp/snmpd.conf: > createUser v3UserName MD5 "v3 user auth" DES "v3 user encry" So you are working with an SNMPv3 user "v3UserName" - OK. > And then I add following contents in /usr/local/share/snmp/snmpd.conf: > com2Sec AdminSecName default v3UserName Nope. "com2sec" is concerned with community-based versions of SNMP. (i.e. SNMPv1/SNMPv2c). It is not relevant to SNMPv3. > group AdminGroup usm AdminSecName Try group AdminGroup usm v3UserName Dave ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users