No trips on MIPS (was: RE: IP redirection)
"Mike Ayers" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <83E753BE7B6A324ABB336245BAF1DAAC08A1AB58@mailserver.metatv-ds.metatv.com> |
[Please change the subject line when using "reply" to start a new thread.] > From: [email protected] > [mailto:[email protected]] On > Behalf Of Rabindra Paikaray > Sent: Wednesday, May 28, 2008 10:31 PM > I have configured net-snmp with disman/event and notification > for linkup and down trap . My traget system is a mips-linux > .While configuring I am getting a warning message like: > configure: WARNING: Can't check sysctl, manually define > NETSNMP_CAN_USE_SYSCTL if platform support available > > But it's comiling without any problem. That's why it's a warning, not an error - it means you should be concerned > While running this in mips board I am not getting any linkUp > Down traps. A Google search on "MIPS linux sysctl" hits several pages such as http://www.linux-mips.org/archives/linux-mips/2007-01/msg00210.html which make it pretty obvious that MIPS linux does indeed have sysctl, so it's probably best to enable it. I believe the correct way to do this is to edit acconfig.h after running configure, and changing the definition of NETSNMP_CAN_USE_SYSCTL from "#undef" to "#define", but, having never done this, I can't be sure. > But If I am compiling it for a general Linux box , it's > giving the trap notification perfectly. There may be some gap in general for MIPS Linux - we are talking about a rather uncommon processor here. HTH, Mike ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users