Re: How to add mib file in net-snmp to perform SET operation.

2008/5/29 rajesh <[email protected]>:
> I added below line
> if (should_init("nstAgentModuleObject")) init_nstAgentModuleObject();
> in **mib_module_inits.h**  file,

That should be done automatically, when you configure the
agent to add your new MIB.

How *exactly* did you try to add your MIB to the agent?


> but when I am executing snmpget , it is crashing .

What is crashing?  The agent or snmpget?
Where exactly is it crashing?

See http://www.net-snmp.org/wiki/index.php/Debugger
for some simple instructions on how to find this out.

Dave

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users