xen snmp mrtg physCPU
"Torstenl" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Hallo snmp-users
On xen-server running any VMs.
net-snmpd is installed on xen0.
MRTG read data from xen0:net-snmpd.
Problem: net-snmp show Load/CPU of Xen0, not of the physical machine.
Xen0Cpu=(physCPU-sum(xenUCPU))
How can i read CPU-Load from a physical machine?
(Not required for network-device. You can use pethX.)
I am checked "snmpwalk .iso.org" , but found nothing.
Alternate, you could install snmp on any VMs,
but condition of the physical machine is interessting only.
regards Torsten
-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users