Re: IP redirection
k_simplydev <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Dave Shield a écrit : > 2008/5/26 k_simplydev <ingenieur.@g>: > >> The private MIB is a customer MIB it could be only on the .20 site cause it >> is an embedded board. >> > > That's fine. > > What I actually meant was to run a GET or GETNEXT request > *from* the 21 system directly, *to* the 20 system. > > >> And if i do requests from .21 to 20 about private MIB, i had correct >> responses. >> > > That sounds like what I was suggesting. > > What is the exact command that you ran on the 20 system? > What was the output? > > What is the proxy directive that you have in your snmpd.conf file? > > > The command i ran on the .20 site is getnext -v 1 -c public -u user .1.3.6.1.4.1.2021.xxx The proxy directive on the snmpd.conf on the .21 system is proxy -v1 -c public -u user 192.168.0.20 .1.3.6.1.4.1.2021 and before i wrote proxy -v1 -c public -u user 192.168.0.20 .1.3 >> It is strange but how can i check that my daemon was built with the >> ucd-snmp/proxy module? >> > > If you've got a proxy directive in the config file, but the agent doesn't > include proxy support, then it will generate an error. > > > Try shutting the agent (on the 20 system) down completely. > Then run > > snmpd -f -Le -Dread-config > > What is the output of this command? > > The output is : "Cannot find the module SNMP-COMMUNITY-MIB at line 0" Thanks a lot for your answers, Dave. And sorry i was too busy to answer before. > Dave > > K. ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users