Configuring MAC address through snmpset

Hi All,
 Which should be used in the snmpset for configuring MAC address?.
  I mean 'i'  for interger and 'a' for IP address like that what should be for MAC address.
Thanks
Bhaskararao.V

________________________________
From: [email protected] [mailto:[email protected]] On Behalf Of kian
Sent: Tuesday, June 17, 2008 5:57 PM
To: [email protected]
Subject: trap

I run notification.c and replace my oid trap,
but dosn`t work correct.
This show:
TRAP6..1 from 192.168.10.138: Enterprise Specific
My trap dosen`t show.

________________________________
"DISCLAIMER: This message is proprietary to Aricent and is intended solely for the use of the individual to whom it is addressed. It may contain privileged or confidential information and should not be circulated or used for any purpose other than for what it is intended. If you have received this message in error,please notify the originator immediately. If you are not the intended recipient, you are notified that you are strictly prohibited from using, copying, altering, or disclosing the contents of this message. Aricent accepts no responsibility forloss or damage arising from the use of the information transmitted by this email including damage from virus."

-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users