Re: snmpd: failed to run mteTrigger query
"Dr. Francesco Rabottini" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Il Saturday 28 June 2008 19:01:10 Dave Shield ha scritto: > 2008/6/27 Dr. Francesco Rabottini <[email protected]>: > > I'm trying to sending traps width snmpd 5.4.1, but I'm getting this > > error: "failed to run mteTrigger query". > > There have been some problems with the linkUp/Down processing > that came to light recently. You might like to try with the 5.4.2.pre2 > code, which should work properly. > > Alternatively, replace the 'linkUpDownNotifications' line with an > equivalent 'monitor' setting. That should work as well. > > > iquerySecName userro > > agentSecName userro > > Note that you only need one of these lines - not both. > > Dave Thx Dave for instant replay. I have omitted the 'linkUpDownNotifications' and the 'agentSecName ' settings but I'm still getting the same error. Best Regards. Dr. Rabottini Francesco. ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users