Re: How to modify the Makefile if I add new files into agent directory
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
[ First - *please* don't mail me privately, without copying
any responses to the mailing list. I don't have the time
or inclination to offer private, unpaid, SNMP consultancy.
Keep discussions to the list, where others can both learn
and offer advice. Thanks. ]
2008/7/8 Zhouhuai Shen <[email protected]>:
> If I run the command "configure --with-mib-modules=myFile", this is the case
> when files have been added into the mibgroup directory.
Correct.
That is where MIB module code should be put.
> If I add files into
> the 'agent' directory, what is the command again?
mv agent/myFile* agent/mibgroup
configure --with-mib-modules=myFile
Dave
-------------------------------------------------------------------------
Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW!
Studies have shown that voting for your favorite open source project,
along with a healthy diet, reduces your potential for chronic lameness
and boredom. Vote Now at http://www.sourceforge.net/community/cca08
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users