RE: Reload MIB file

 
> > 
> > I directly updated the MIB so that the MIB under 
> > /usr/local/share/snmp/mibs is now the newer version (same 
> name). I did 
> > have MIBS set to all.
> 
> 	Hmmm... that should work.  Did you perhaps change the 
> name of an imported object?  If so, you must change the name 
> where it is imported as well.  There is an object being 
> imported from CISCO-DMP-MIB (yours?) into UCD-DEMO-MIB - is 
> that perhaps an old test that you never cleaned up?
> 
> 
Thanks for your help. Found that I had another MIB under
/usr/local/share/snmp/mibs with the same name but a different extension
(CISCO-DMP-MIB.txt_old_type) which I had used some time back and
forgoten about it. Somehow that was causing the problem. Not sure why
the problem didn't surface earlier (or maybe I didn't notice!) This old
file had the same object name but the type of the object was different.
Once I changed the name in the working file (but left the old one as
is), it started created problems.

Anyway, I deleted the old file and it works now!

Regards,
Mitul

------------------------------------------------------------------------------
This SF.net email is sponsored by:
SourcForge Community
SourceForge wants to tell your story.
http://p.sf.net/sfu/sf-spreadtheword
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users