RE: Sending Traps for different destinations at the same time
"Angela Lazaro" <[email protected]>
| Newsgroups | gmane.network.net-snmp.devel,gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Thanks Dave!!! I've tried that without success.... I defined two trapsess and the agent do not run properly and do not answer to the requests. I do not know why. But since I know it's possible and that should work, I will try to do some trace in order to understand what's the problem. Thanks again, Ângela -----Original Message----- From: [email protected] on behalf of Dave Shield Sent: Sat 1/31/2009 10:50 AM To: Angela Lazaro Cc: [email protected]; [email protected] Subject: Re: Sending Traps for different destinations at the same time 2009/1/30 Angela Lazaro <[email protected]>: > ... if I want to use only SNMPv3, how can I send a multi destination trap? Use two "trapsess" directives. Each such line (be it trapsess, trapsink, etc) will configure a separate trap destination. If you have 28 such lines in your config file, you will end up sending 28 copies of each trap! Dave ------------------------------------------------------------------------------ This SF.net email is sponsored by: SourcForge Community SourceForge wants to tell your story. http://p.sf.net/sfu/sf-spreadtheword _______________________________________________ Net-snmp-coders mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/net-snmp-coders