Re: UCD-SNMP-MIB returns Empty

Hi Dave,

This is how my conf file looks now..

rwcommunity public
includeAllDisks 100%

but still I coudnt get disk details even for single partition...I read in
one forum that some agent wont support "includeAllDisks"property
sometime..is it like that?..If I specify each partition name, then I able to
get values..But I dont want to specify like that..

how should I add "includeAllDisks" in snmpd.conf file?...

Thanks & Regards
Malar


On Mon, Mar 9, 2009 at 8:28 PM, Dave Shield <[email protected]>wrote:

> 2009/3/9 malar vizhi <[email protected]>:
> >      I thought of retrieving disk related details......
> > So, I just include "disk / ". With
> > this I able to get only the details for partition "/".
>
> So that much is working - good.
>
> > But there are 7 partitions.
> > Is there any general configuration name to get details of all 7
> partitions?
>
> Yes
>
> > I tried by including "includeAllDisk".
>
> Very nearly...  But not quite right.
>
>
> >    ..... But I coudnt see any disk details.
>
>   $ man snmpd.conf
>      :
>   includeAllDisks MINPERCENT%
>      :
>
> Note the name of the directive.  It's not quite the same as what you're
> using.
>
> Dave
>

------------------------------------------------------------------------------

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users