Re:

Hi ALL,
       Is it possible to implement the Ether-Like mib , rfc 3635 using 
the "ethtool" ?

Thanks and Regards,
Sanjay kumar


Dave Shield wrote:
> 2009/4/7 Michael Schwartzkopff <[email protected]>:
>   
>>> In general, the speed of an interface is typically controlled by the
>>> hardware.   I'm not aware of any mechanism (either via SNMP
>>> or on the command line) that would allow you to change this
>>>       
>> ethtool
>>     
>
> So noted.   Thanks.
>
> Though of course, that is specific to Ethernet-style interfaces.
> (While the IF-MIB is a much more generic thing).   Do you
> happen to know if there are similar tools for other types of interface?
>
> I suspect that this sort of management control might need to be
> handled by type-specific MIBs, rather than the generic IF-MIB.
>
> But of course, this is really a question for the IETF, rather than
> to be unilaterally decided by one individual SNMP product  :-)
>
> Dave
>
> ------------------------------------------------------------------------------
> This SF.net email is sponsored by:
> High Quality Requirements in a Collaborative Environment.
> Download a free trial of Rational Requirements Composer Now!
> http://p.sf.net/sfu/www-ibm-com
> _______________________________________________
> Net-snmp-users mailing list
> [email protected]
> Please see the following page to unsubscribe or change other options:
> https://lists.sourceforge.net/lists/listinfo/net-snmp-users
>
>   


------------------------------------------------------------------------------
This SF.net email is sponsored by:
High Quality Requirements in a Collaborative Environment.
Download a free trial of Rational Requirements Composer Now!
http://p.sf.net/sfu/www-ibm-com
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users