Re: Problem with snmpset.
Dave Shield <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
2009/5/12 Noppadol Sotanakul <[email protected]>: > I would like to set the value of prErrFix (variable in prTable). > Then I set its value to '1' using snmpset command (snmpset -v 1 -c public > localhost prErrFix.1 i 1), the result shown that prErrFix was set to '1'. And does the command listed in 'prErrFixCmd' get run? > After that I get its value using the same command to check it again, but its > value still was INTEGER: noError(0). That is correct. The object prErrFix is a "push button" object. You apply a SET command in order to invoke the corresponding prErrFixCmd, but the value of prErrFix then automatically reverts to 0. Whenever you read this object, it will *always* be 0. Dave ------------------------------------------------------------------------------ The NEW KODAK i700 Series Scanners deliver under ANY circumstances! Your production scanning environment may not be a perfect world - but thanks to Kodak, there's a perfect scanner to get the job done! With the NEW KODAK i700 Series Scanner you'll get full speed at 300 dpi even with all image processing features enabled. http://p.sf.net/sfu/kodak-com _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users