MailScanner and Mail Stats

Hi there,

I have been running sendmail.

To monitor the queues I have been looking at the data under the MIB
mtaGroupStoredMessages and mtaGroupStoredVolume.

I decided to install MailScanner to add antivirus and antispamming.

MailScanner works by reading all the mail that is placed in sendmails
queue and processing it. If the mail is good then it is placed in a
second queue for sending.

My problem is I can't seem to see any MIB that reads the total and
volume in the second queue.

Can anyone help?

Michael Hampton


http://www.vital-group.com    - Dedicated to business communications.
http://www.vital-storage.com  - Secure easy-to-use remote backups for business critical data.

The information contained in this message is intended for the addressee only and may contain confidential and/or privileged information.If you are not the addressee, please delete this message and notify the sender; you should not copy or distribute this message or disclose its contents to anyone.Any views or opinions expressed in this message are those of the author and do not necessarily represent those of The Vital International Group or any of its affiliates.No reliance may be placed on this message without written confirmation from an authorised representative of its contents.

No binding contract will be made between an employee of The Vital Group and a third party either verbally or by email, until a written document has been signed on behalf of The Vital Group.

Registered in England. Vital International Limited. Leigh House, Weald Road, Brentwood, Essex, CM14 4SX.Company registration number - 45022560.

------------------------------------------------------------------------------
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users