Re: snmptrapd only

Thanks Dave for your reply.

Well... i tried removing the "disableAuthorization yes" entry from the
snmptrapd.conf well.. i do not get any traps... i get the below message
(just pasting the last messages)


> Cannot find module (SNMPv2-MIB): At line 0 in (none)
> Cannot find module (SNMPv2-SMI): At line 0 in (none)
> Cannot find module (SNMP-VIEW-BASED-ACM-MIB): At line 0 in (none)
> Cannot find module (SNMP-COMMUNITY-MIB): At line 0 in (none)
> Warning: no access control information configured.
>   It's unlikely this agent can serve any useful purpose in this state.
>   Run "snmpconf -g basic_setup" to help you configure the snmptrapd.conf
> file fo
> r this agent.
> *Warning: no access control information configured.*
> *This receiver will *NOT* accept any incoming notifications.*
> NET-SNMP version 5.3.0.1
>

Btw, when  "disableAuthorization yes" was present in the snmptrapd.conf, i
use dto get as below


> Cannot find module (SNMPv2-SMI): At line 0 in (none)
> Cannot find module (SNMP-VIEW-BASED-ACM-MIB): At line 0 in (none)
> Cannot find module (SNMP-COMMUNITY-MIB): At line 0 in (none)
> *snmptrapd.conf: line 13: Warning: Unknown token: disableAuthorization*.
> Warning: no access control information configured.
>   It's unlikely this agent can serve any useful purpose in this state.
>   Run "snmpconf -g basic_setup" to help you configure the snmptrapd.conf
> file fo
> r this agent.
> *Warning: no access control information configured.
> This receiver will *NOT* accept any incoming notifications.*
> NET-SNMP version 5.3.0.1


Any suggestions? Please help!!

Are there any modules(configure options) that have no dependencies on
snmptrapd functionality?

Regards,


>
>
>
On Tue, Mar 2, 2010 at 3:32 PM, Dave Shield <[email protected]>wrote:

> On 2 March 2010 09:27, Queenie de Melo <[email protected]> wrote:
> > I tried configuring using --disable-agent but when i run it, it says that
> > the disableAuthorization is an unknown token in the snmptrapd.conf.
>
> Try removing this entry from the config file.
> If the trap receiver doesn't have the code to parse this config token,
> it's likely that it doesn't have the code to check access anyway.
>
> See what happens if you run the stripped-down trap receiver
> without this token.  Can you receive traps or not?
>
> Dave
>

------------------------------------------------------------------------------
Download Intel&#174; Parallel Studio Eval
Try the new software tools for yourself. Speed compiling, find bugs
proactively, and fine-tune applications for parallel performance.
See why Intel Parallel Studio got high marks during beta.
http://p.sf.net/sfu/intel-sw-dev

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users