Re: Please i need support

Check the Cisco site and the manuals that come with the device and see
if your device has an embedded SNMP agent, if it does you can then run
commands to get information from it.  Read up on the commands you can
use at

http://net-snmp.sf.net/

Good luck!

On Wed, May 19, 2010 at 11:17 PM, Mahmmoud Rashed
<[email protected]> wrote:
>
>
> Dear supporter,
> I have a Cisco access point WAP200, Which is connected to my computer
> through a cable.. Can i run a command to get the RSSI (Signal Stregth) per
> DBm between it and any client that is connected to the access point. thanks
> for your support.
>
>
> ________________________________
> Hotmail: Powerful Free email with security by Microsoft. Get it now.
> ------------------------------------------------------------------------------
>
>
> _______________________________________________
> Net-snmp-users mailing list
> [email protected]
> Please see the following page to unsubscribe or change other options:
> https://lists.sourceforge.net/lists/listinfo/net-snmp-users
>
>

------------------------------------------------------------------------------

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users