RE: Problems with SNMPv3 and SHA

> From: Michael Bayer [mailto:[email protected]]

> createUser myuser MD5 mypasswd

> Than I added the following line:
> createUser myuser SHA mypasswd

> And now I get an error message:
> 
> snmpget: Authentication failure (incorrect password, community or key)
> (Sub-id not found: (top) -> system)
> 
> Somehow SHA doesn't work + now the OID is not found. Did I miss

  Are you sure that the host running your net-snmp agent has the OpenSSL
libraries, and that the agent was built to link those libraries?  These
conditions must be met in order to use any authentication (guess how I
know? ;).

  Try running this command on your agent host:

net-snmp-config --configure-options

  If the results contain '--without-openssl' then you need to rebuild
snmpd.

  Ron



The information contained in this message may be privileged and confidential and protected from disclosure. If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by replying to the message and deleting all copies. Thank you.

------------------------------------------------------------------------------
ThinkGeek and WIRED's GeekDad team up for the Ultimate 
GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the 
lucky parental unit.  See the prize list and enter to win: 
http://p.sf.net/sfu/thinkgeek-promo
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users