Re: need a help
Wes Hardaker <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Organization | Sparta |
| Message-ID | <[email protected]> |
>>>>> On Thu, 10 Jun 2010 16:35:19 +0530, gunsnroses <[email protected]> said: g> (1) I need to modfy linkUpDownNotifications backend. I am working on switch g> port interfaces, and to get to know the true state of an interface I need to g> run a binary for each interface. So, I have to get to know the exact part of g> code which gets to know the status of the interfaces and instead of knowing g> like that I will execute my binary there. How do I do this? It may depend on the OS, but start in agent/mibgroup/if-mib/ifTable/ifTable_data_access.c send_linkUpDownNotifications() g> I think that I wont get separate traps for scenario------part1-->goes above g> 90% & after some time part2--->goes above 90% and after some time part3---> g> goes above 90%. How can I make this possible? It should. Have you tried it? (try it; set the values low near the point that they're currently at space wise and then create a big file in each disk to ensure your configuration will work). g> (3) Also, I have to monitor if any of the usage in these partitions crosses g> 96%. Can I do another monitor with dskPath in sanmpd.conf withe the above g> where it is tracking for 90%? How? No, unfortunately it's a single warning level. -- Wes Hardaker Cobham Analytic Solutions ------------------------------------------------------------------------------ ThinkGeek and WIRED's GeekDad team up for the Ultimate GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the lucky parental unit. See the prize list and enter to win: http://p.sf.net/sfu/thinkgeek-promo _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users