RE: Any way to have trapsink or trap2sink send traps to a given destination ONLY if the OID matches a configured OID prefix?

I have the very same problem - so if you find a solution can you post it
to this user list also?
Thanks

-----Original Message-----
From: Max [mailto:[email protected]] 
Sent: Friday, June 18, 2010 10:51 AM
To: Dave Shield
Cc: SNMP FORUM
Subject: Re: Any way to have trapsink or trap2sink send traps to a given
destination ONLY if the OID matches a configured OID prefix?

On Fri, Jun 18, 2010 at 6:09 AM, Dave Shield
<[email protected]> wrote:
> Have you looked at using the 'snmpNotifyFilterTable' ?
> That would seem to meet your requirements.

Will do - I wish I could find an example snmpd.conf use of this table
for this purpose, but I cannot.  When I do figure out how to use it I
will contribute a HOW-TO on the Net-SNMP Wiki.

- Max

------------------------------------------------------------------------
------
ThinkGeek and WIRED's GeekDad team up for the Ultimate 
GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the 
lucky parental unit.  See the prize list and enter to win: 
http://p.sf.net/sfu/thinkgeek-promo
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users

------------------------------------------------------------------------------
ThinkGeek and WIRED's GeekDad team up for the Ultimate 
GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the 
lucky parental unit.  See the prize list and enter to win: 
http://p.sf.net/sfu/thinkgeek-promo
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users