Re: Does net-snmp support IPv4 and IPv6 at a time ?
Dave Shield <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 7 July 2010 10:16, sanjaykumar <[email protected]> wrote: > What will be value of macro "NETSNMP_ACCESS_ARP_IPADDR_BUF_SIZE" in > following structure > > typedef struct netsnmp_arp_s That depends on how you've compiled the software. If you've enabled IPv6 support, then the 'arp_ipaddress' buffer will be 16 bytes - big enough to hold either an IPv4 or an IPv6 address. If you haven't enabled IPv6 support, then the buffer will be 4 bytes - big enough to hold an IPv4 address. (It doesn't need to be any bigger than this for an IPv4-only configuration, so it would be wasteful to make it larger) > There are other structure also available which has similar > macro for size of IP Address. The same reasoning will doubtless apply there too. Dave ------------------------------------------------------------------------------ This SF.net email is sponsored by Sprint What will you do first with EVO, the first 4G phone? Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users