Re: Please advise about snmpget over IPv6
Dave Shield <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 19 August 2010 15:45, Ron Rader <[email protected]> wrote: > The following command (using net-snmp tools v5.5) allows me to query > net-snmp agents (v5.5) to walk the MIB (using SNMPv3 and IPv6): > > snmpwalk -v 3 -n "" -u auser -l authNoPriv -a MD5 -A password udp6:[2003:a8::208] system > > However, the same host times out when I try to switch to SNMPv2c: > > snmpwalk -v 2c -c public udp6:[2003:a8::208] system > > That seems strange to me. What are the access control settings in your 'snmpd.conf' file? Remember that for community-based requests using IPv6 you need to use "rocommunity6" rather than "rocommunity" Dave ------------------------------------------------------------------------------ This SF.net email is sponsored by Make an app they can't live without Enter the BlackBerry Developer Challenge http://p.sf.net/sfu/RIM-dev2dev _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users