Re: net-snmp 5.6.X compilation errors in QNX Momentics 6.3.0
Abraham Varricatt <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On Thu, Sep 16, 2010 at 1:17 PM, Ali Mirza, Rashid <[email protected] > wrote: > My error message was : > > > > make[1]: *** No rule to make target > mibgroup/ip-mib/ipv6ScopeZoneIndexTable/ipv6ScopeZoneIndexTable_data_access.h' > , needed by 'agent_index.lo'. Stop > This is something a bit beyond me. What it looks like, is that the ./configure was not able to setup the Makefiles to your environment. What I was hoping earlier, was to run the configure script so that only the most essential of MIB's would be built. But it looks like even that is creating problems. Try asking the net-snmp-codes group, perhaps someone there has an idea. Also - did you try running "make clean" before each try? (to clean out any old data) Wishing I could be of more help, Abraham Varricatt ------------------------------------------------------------------------------ Start uncovering the many advantages of virtual appliances and start using them to simplify application deployment and accelerate your shift to cloud computing. http://p.sf.net/sfu/novell-sfdev2dev _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users