Re: net-snmp 5.6.X compilation errors in QNX Momentics 6.3.0

On Fri, Sep 17, 2010 at 09:17:20AM +0530, Abraham Varricatt wrote:
> On Thu, Sep 16, 2010 at 1:17 PM, Ali Mirza, Rashid <[email protected]
> > wrote:
> 
> >  My error message was :
> >
> >
> >
> > make[1]: *** No rule to make target
> > mibgroup/ip-mib/ipv6ScopeZoneIndexTable/ipv6ScopeZoneIndexTable_data_access.h'
> > , needed by 'agent_index.lo'. Stop
> >
> 
> This is something a bit beyond me. What it looks like, is that the
> ./configure was not able to setup the Makefiles to your environment. What I
> was hoping earlier, was to run the configure script so that only the most
> essential of MIB's would be built. But it looks like even that is creating
> problems. Try asking the net-snmp-codes group, perhaps someone there has an
> idea.
> 
> Also - did you try running "make clean" before each try? (to clean out any
> old data)
> 
> Wishing I could be of more help,
> Abraham Varricatt


Check out these two links:

http://community.qnx.com/sf/projects/networking
http://community.qnx.com/sf/wiki/do/viewPage/projects.networking/wiki/Netsnmp_wiki_page

I got 5.5 (I think that was the version) building against qnx 6.5
and sent the patches back. qnx 6.3 is pretty old.

Regards,

-seanb

------------------------------------------------------------------------------
Start uncovering the many advantages of virtual appliances
and start using them to simplify application deployment and
accelerate your shift to cloud computing.
http://p.sf.net/sfu/novell-sfdev2dev
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users