snmpset gives an gen Error message

Hi,
 
I've been extending the snmpd with my own modules.  I made sure that each module is working properly before adding another one.
 
Suddendly, on one of the latest modules, netsnmp builds ok, but I get an error while using snmpset command.
 
I also tested the snmpset with a library in c# separate from netsnmp, and it does not work either.
 
I removed the module, and re-build the netsnmp and still gives me the error.
 
The error is:
 
$snmpset -v1 -cprivate localhost myvar.0 i 0
Error in packet.
Reason: (genError) A general failure occured
 
it happens with each oid I've implemented.  I'm using net-snmp-5.6.rc1.
 
I also though that maybe the modules that I've extended created some seg-fault, and overwrite some source/header files in net-snmp, so I re-install (tar) the whole netsnmp, but I still get the error.
 
I'm not too sure what could cause this sudden error.  I reverted to only the modules that was working fine before, and I did not change the MIB or the snmpd.conf files.
 
Thanks!
 
Leo;

------------------------------------------------------------------------------
Download new Adobe(R) Flash(R) Builder(TM) 4
The new Adobe(R) Flex(R) 4 and Flash(R) Builder(TM) 4 (formerly 
Flex(R) Builder(TM)) enable the development of rich applications that run
across multiple browsers and platforms. Download your free trials today!
http://p.sf.net/sfu/adobe-dev2dev

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users