Memory leak when using monitor

I am testing net-snmp on and embedded ARM board and I have found what appears to be a memory leak in net-snmp, when using the monitor command in snmpd.conf. The memory leak only seems to occur with r values other than the default 600s. I have added the following lines to my snmpd.conf file and tested with both 5.6.1.1 and the latest svn as of today. 

proc test
monitor -S -r 33 -o prNames -o prErrMessage "Process Table" prErrorFlag 0 1

The value of r has an impact on the rate of the memory leak. Using a value of 33s shows the memory increase after approximately 6 minutes then and further increases at approximately 10 minute intervals.

time minutes    vsz
   0           7576
   6           7704
  16           7832
  26           7960
  36           8088
  46           8212
  56           8340

Using r set to 30 or 60 gives an increase in vsize after 11minutes then at intervals of approximately 18 minutes??

Has anybody else come across this problem?

Chris

------------------------------------------------------------------------------
All of the data generated in your IT infrastructure is seriously valuable.
Why? It contains a definitive record of application performance, security 
threats, fraudulent activity, and more. Splunk takes this data and makes 
sense of it. IT sense. And common sense.
http://p.sf.net/sfu/splunk-d2d-c2
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users