Re: Memory leak when using monitor
Chris Down <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Organization | Alcor Communications Ltd |
| Message-ID | <[email protected]> |
On 29/06/2011 15:19, Chris Down wrote: > I am testing net-snmp on and embedded ARM board and I have found what appears to be a memory leak in net-snmp, when using the monitor command in snmpd.conf. The memory leak only seems to occur with r values other than the default 600s. I have added the following lines to my snmpd.conf file and tested with both 5.6.1.1 and the latest svn as of today. > > proc test > monitor -S -r 33 -o prNames -o prErrMessage "Process Table" prErrorFlag 0 1 > > The value of r has an impact on the rate of the memory leak. Using a value of 33s shows the memory increase after approximately 6 minutes then and further increases at approximately 10 minute intervals. > > time minutes vsz > 0 7576 > 6 7704 > 16 7832 > 26 7960 > 36 8088 > 46 8212 > 56 8340 Just for info, this memory leak seems to have been fixed for 5.7. Chris ------------------------------------------------------------------------------ All of the data generated in your IT infrastructure is seriously valuable. Why? It contains a definitive record of application performance, security threats, fraudulent activity, and more. Splunk takes this data and makes sense of it. IT sense. And common sense. http://p.sf.net/sfu/splunk-d2d-c2 _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users