IF-MIB::ifSpeed shows wrong value for bonded interface
Dheeraj Gautam <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Hi, On our system we added bonded interface with link-agg-layer3+4 mode and bonded two 1G Ethernet interfaces to the bond. But IF-MIB::ifSpeed is showing as 10Mbps only. IF-MIB::ifSpeed.10 = Gauge32: 10000000 We expected this to be shown as 2Gbps. * Did anybody else also faced this issue ? * Any possible reason of this issue ? We are using Net-SNMP version 5.3.1 and linux Centos EL5 with kernel 2.6.18-164.15.1.el5 -Dheeraj ------------------------------------------------------------------------------ Storage Efficiency Calculator This modeling tool is based on patent-pending intellectual property that has been used successfully in hundreds of IBM storage optimization engage- ments, worldwide. Store less, Store more with what you own, Move data to the right place. Try It Now! http://www.accelacomm.com/jaw/sfnl/114/51427378/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users