RE: SNMP V3 help needed Urgent

> On 22 November 2011 19:28, Abhishek Kumar-Noida <[email protected]>
> wrote:
> > I am trying to get SNMPWALK from V3 however unable to do the same. I
> > am getting SNMPWALK via V2 from same host however not from V3.
> 
< Dave Shield's response deleted. >

If all still fails after you've tried what Dave suggests, then try specifying the snmpd configuration files when you start the agent as below. I had heaps of trouble getting v3 to work until I did this:

# /opt/snmp/sbin/snmpd -Le -f -c /opt/snmp/share/snmp/snmpd.conf,/var/net-snmp/snmpd.conf -C &

Note that my installation does NOT use the default locations, and although I (think I) built the agent correctly, v3 would not run until I did the above. (Of course, replace my snmpd.conf file paths with your own.)

Good luck.

John

----------------------------------------------------------------
John Leiseboer                    QuintessenceLabs Pty Ltd
Chief Technology Officer          Suite 23, Physics Building #38
P: +61 7 5494 9291                Science Road
F: +61 2 6125 7180                Australian National University
M: +61 409 487 510                Acton, ACT 0200 Australia
mailto:[email protected]    www.quintessencelabs.com
----------------------------------------------------------------

------------------------------------------------------------------------------
All the data continuously generated in your IT infrastructure 
contains a definitive record of customers, application performance, 
security threats, fraudulent activity, and more. Splunk takes this 
data and makes sense of it. IT sense. And common sense.
http://p.sf.net/sfu/splunk-novd2d

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users