SNMPv3 trapsess Definition and Engine ID in 5.7.1
Gary Dunlap <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Hi. Is there any syntax change required for "trapsess -v 3" or "engineIDType" statements in snmpd.conf, in Net-SNMP 5.7.1? I'm comparing to 5.6.1. It appears that this trapsess user does not become part of the userList, either in the MIB usmUserTable or the internal userList. Then no trap gets sent, because the USM name wasn't found. It appears there's a new function usm_create_user_from_session() and some logic around the presence/timing of the engine ID. The function isn't running due to flags set to "DON'T_PROBE" for engineID and an apparent engine ID length of 0. I do have an engineID, generated by "engineIDType 3" and present in /var/net-snmp/snmpd.conf. Does the engineIDType statement need to be first or something? Thanks. Gary Gary Dunlap Dot Hill Systems 1351 S Sunset St Longmont, CO 80501-6533 303-845-3277 ------------------------------------------------------------------------------ Virtualization & Cloud Management Using Capacity Planning Cloud computing makes use of virtualization - but cloud computing also focuses on allowing computing to be delivered as a service. http://www.accelacomm.com/jaw/sfnl/114/51521223/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users