Re: Timeout

Hi,

I get nothing, i get the same message : Timeout: No Response from <IP>
so , are there other solutions to solve this problem ?

Abid


2013/7/26 Lee <[email protected]>

> On 7/26/13, Abid Ayoub <[email protected]> wrote:
> >
> > I think that the problem is in udp port or in ip adresse because there is
> > only one community string configured and have already tried the command
> > with "v2c" and "v3".
> >
> > So any idea how can i change the port used by net-snmp and be certain
> that
> > cisco is configured to accept requests from your IP address?
>
> The port number isn't the problem.  To see what's happening on the
> switch, get into enable mode on the switch & do
> conf t
> snmp-server community zuperZekret ro
> end
> term mon
> debug snmp packets
>
> Then from your PC do
> snmpget -v 2c -c zuperZekret <ip address of switch> .1.3.6.1.2.1.1.5.0
>
> that should give you enough information to figure out what the problem is
>
> Regards,
> Lee
>
>
>
> >
> > Thanks
> > Abid
> >
> >
> >
> > 2013/7/25 Fulko Hew <[email protected]>
> >
> >>
> >>
> >> On Thu, Jul 25, 2013 at 10:13 AM, Abid Ayoub <[email protected]>
> >> wrote:
> >>
> >>> Hello,
> >>>
> >>> This is the first time that i use net-snmp.
> >>> So, i want to know the general configuration and other informations
> >>> about
> >>> my cisco switch using snmpwalk and snmpget.
> >>>  So , i use the following command:
> >>>
> >>> snmpget -c <community> -v2c <IP> 1.3.6.1.6.1
> >>>
> >>> but i get immer :
> >>>
> >>> Timeout: No Response from <IP>
> >>>
> >>> i connect to the switch using ssh , but the command don´t work .
> >>>
> >>> So , any idea about the problem ? what is wrong ?
> >>>
> >>
> >> Only the obvious:
> >>
> >> - a firewall is blocking UDP port 161 between yr box and the Cisco
> switch
> >> - you are using the wrong community string
> >> - your Cisco isn't configured to support SNMP v2c
> >> - your Cisco isnt' configured to accept requests from your IP address.
> >>
> >> FYI:
> >> Since the OID you stated isn't an ultimate variable, but just a branch
> in
> >> the tree...
> >> you will (eventually) get a 'noSuch' response.  Once you get your other
> >> issue resolved,
> >> either specify a real variable, or use snmpwalk instead.
>

------------------------------------------------------------------------------
See everything from the browser to the database with AppDynamics
Get end-to-end visibility with application monitoring from AppDynamics
Isolate bottlenecks and diagnose root cause in seconds.
Start your free trial of AppDynamics Pro today!
http://pubads.g.doubleclick.net/gampad/clk?id=48808831&iu=/4140/ostg.clktrk

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users