RE: SNMPGet and Log to file

Hi Again,

Just re-posting as I still haven't come up with a resolution to this yet and hope someone can help.

Thanks Heaps!

Daniel

-----Original Message-----
From: Daniel Wilkes [mailto:[email protected]]
Sent: Thursday, 20 March 2014 12:06 p.m.
To: [email protected]
Subject: SNMPGet and Log to file

Hi All,

I'm new to the world of SNMP and am trying to get snmpget to log the result to a file so I can then parse the result into our SCADA system.

The command I am using is:

snmpget -v 2c -Lf "c:\Net SNMP\Output.txt" -c <community name withheld > <IP address withheld> 1.3.6.1.4.1.14817.3.3.2.20.1.5.2

And the result is:

SNMPv2-SMI::enterprises.14817.3.3.2.20.1.5.2 = INTEGER: -1029

The "c:\Net SNMP\Output.txt" gets created but it is a zero byte file that has nothing in it, when I expect it to contain the same result text as is displayed on the screen. What am I doing wrong?

Thanks

Daniel.

________________________________
The information contained in this email message is CONFIDENTIAL INFORMATION and may also be LEGALLY PRIVILEGED. It is intended only for the individual or entity named above. If you are not the intended recipient, you are hereby notified that any use, review, dissemination, distribution or copying of this document is strictly prohibited. If you received this document in error, please immediately notify us by telephone (+64-3-3118900) and destroy the original message.

______________________________________________________________________________

This email has been scrubbed for your protection by SMX.
For more information visit http://smxemail.com
______________________________________________________________________________


------------------------------------------------------------------------------
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users