SNMPSET data resets on hardware reboot
Vince Hurst <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <1FD80A08FCC8CF40892BAD929294AF392165FDE8@S-WEXMB1.win.root.sonoma.gov> |
I can set data fine. (ie: sysName.0 ; sysContact.0 ; sysLocation.0) When I re-probe the devices with my NMS, the data I set shows up. However, if I reboot the device, the data fields return to the default values. I've seen this with a couple different devices. The example I'll use in this case is a Vivotek IP8133 IP Camera (firmware: 0200a). I tried using the device's web GUI "Save" button to save the current configuration to the device while the data was active, but it still clears. Are there any SNMP commands to invoke a "Save"? Someone must have run into this before. Suggestion? Thanks! -Vince ------------------------------------------------------------------------------ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users