Re: Unable to send SNMP V3 Informs to multiple destinations

Hi Robert,

Thanks for your reply and sorry for the delayed response.

I had an error on my side due to which I was not interpreting the informs
at the other end. Now I could test SNMP V3 informs with the same or
multiple users to different destinations.

However I am seeing a behavior which I would like to know whether it is
normal with V3?

I have configured two inform destinations but not started one of the
destinations trap receiver or made the network to go down, at that time if
I start the agent then agent is not functional. Agent is waiting for the
second destination to be available until then I am not receiving cold start
trap at either of the destinations. I see debug message Net-Snmp 5.7.3
comes only after all the destinations are available and takes few seconds
after the above message to send the inform. From then onwards I am able to
receive all the subsequent informs and acknowledgements.

Appreciate your help.

Thanks.

Raja.

On Fri, Jul 17, 2015 at 2:56 PM, Robert Story <[email protected]> wrote:

> On Wed, 8 Jul 2015 17:03:09 -0500 raja wrote:
> RV> If I try to send Informs to more than one destination with the
> RV> same user or different user then just cold start trap is being
> RV> delivered to all destinations but subsequent Informs are
> RV> delivered to only the first destination in the snmpd.conf.
>
> Hi Raja,
>
> Something is definitely wrong. You should be able to send multiple
> informs to different destinations. Try adding some debg tokens to
> your snmpd command line: "-D trap,send,transport:send" to see
> what's happening.
>
> Robert
>

------------------------------------------------------------------------------

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users