Re: SNMPv3 SHA support

Hi Wes,

Thanks for reply, I get the SHA working on my setup. Actually I was using
-3M and -3m for auth and priv pass. These were working only for MD5 and
DES/AES protocol but not for SHA. Then I change the option from -3M to -m
and -3m to -m and now all the combination of auth and priv pass are
working.

Thanks
Vijendra.
On 29/09/15 5:34 am, "Wes Hardaker" <[email protected]> wrote:

>"Vijendra Agarwal (vijagarw)" <[email protected]> writes:
>
>> Can anybody please let me know If I need to configure/check anything
>> else to make SHA protocol works?
>
>Did you set up access control rights too?
>-- 
>Wes Hardaker
>Parsons


------------------------------------------------------------------------------
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users