Re: com2sec in snmpd.conf
Pushpa Thimmaiah <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <CAASqVJVjkS3KFqRbAkMqAo7NeTcFY_aiku-1tkAqEheBCw=FFg@mail.gmail.com> |
I got the answer from https://www.mail-archive.com/[email protected]/msg08821.html . keyword 'default' refers to '0.0.0.0' (ipv4) snmplib/transports/snmpUDPDomain.c (netsnmp-5.7.1) corresponding code. Thank you. On Wed, Oct 28, 2015 at 3:20 PM, Pushpa Thimmaiah < [email protected]> wrote: > Hi Folks, > > I have seen value of 'source' as 'default' in label 'com2sec' like > following > #sec.name source community > com2sec readonly default test1 > > What does 'default' refer to? is it localhost ? > > > Thank you, > Pushpa.T > > ------------------------------------------------------------------------------ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users