Compile snmpd from source
Zvi Vered <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <CABRndgz0uRNjNC3xqT4RJdq=Zii8U7LUb4-RLqVji6w2gqN1AA@mail.gmail.com> |
Hello, Under Centos 6.4 I installed snmpd. It runs from /usr/sbin Then I installed the sources (in my case net-snmp 5.5) and installed them with: ./configure make make install The snmpd binary was installed in /usr/local Running: "service snmpd restart" running the original /usr/snmpd When I tried to: "cp /usr/local/snmpd /usr/sbin" and run the snmpd I got: .... Warning: no access control information configured. It's unlikely this agent can serve any useful purpose in this state. Run "snmpconf -g basic_setup" to help you configure the snmpd.conf file for this agent. NET-SNMP version 5.5 And the agent is not responding to the MIB browser. Can you please help ? Thank you, Zvi Vered ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users