snmpd.conf : interface group

Hello,

Do you have a sample of list of interface I can put in snmpd.conf ?

My x86 manages a switch. It runs snmpd. This x86 has few etherent devices.

I think (not sure) that by default, ifNumber is the number of those devices. 
Am I right ?

In my case the number of devices is 16 which are the number of ports in the 
switch.

Best regards,
Z.V 


------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are 
consuming the most bandwidth. Provides multi-vendor support for NetFlow, 
J-Flow, sFlow and other flows. Make informed decisions using capacity 
planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users