How to clean USM config
徐 勇 <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <HK2PR01MB097874349932F27411CDC753B2500@HK2PR01MB0978.apcprd01.prod.exchangelabs.com> |
Hi, I used Net-SNMP in my project, and I found that when I had added an snmpv3 user by snmpd.conf (createUser directive), I cannot change the auth/priv password of the user by updating snmpd.conf, even have a restarting the snmpd process. And then I found this is caused by the usm lists. it seems a global usm lists is used to stored the password, and the list is not belong to snmpd. Even when I stop snmpd, or delete the v3 user, I can get the system usm record which is added by the createUser directive ( I use snmp-walk on 1.3.6.1.6.3.15.1.2.2.1 for checking this). I know snmpusm tool can update the usm password, but that tool need another RW v3 user. I'm wondering if there's a convenient method to modify the password of an existed v3 user, or delete/cleanup the exited usm list ? Thanks Yong ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users