netsnmp_config

I have found that I can add a trap destination in code by using the following commands

            netsnmp_config ("trapcommunity test");
            netsnmp_config ("trap2sink 10.7.7.105");

Everything works perfectly, when the board is rebooted, the trap destination goes away as expected.

My question is how to remove the newly created trap destination without rebooting/restarting snmpd

Any hints would be appreciated,
Thanks

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users