How to start snmpd without any MIB module

Hi,

I'm confused about the -I option, what's the default behavior on the mib modules inclusion?

If I want to start snmpd without any MIB supported(in fact, I want to implement most them in subagent) , how to?

      -I [-]INITLIST
               This option specifies which modules you do (or do not) want  to
               be  initialized  when  the agent starts up.  If the comma-sepa-
               rated INITLIST is preceded with a ’-’, it is the list  of  mod-
               ules  that  you do not want to be started.  Otherwise, INITLIST
               is the list of modules to be started.

               To get a list of compiled modules, run the agent with the argu-
               ments  -Dmib_init  -H  (assumes you have debugging support com-
               piled in).


Thanks

Bill

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users