Re: UPDATE: Starting snmpd deliver 128 duplicate notifications to each trap2sink destinations
Bill Fenner <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <CAF4SogZzWWOx3=vJSAVNvc7L8=KXXJ+MR4g6sg9MXB8Uci2i2w@mail.gmail.com> |
On Mon, Jan 1, 2018 at 11:33 PM, Jose Roberto Fernandez Anahia < [email protected]> wrote: > Hello Bill, > Thank you for your post. > > Well, I tried some configurations in my snmpd.conf, disabling ipv6, listen > in only one interface, etc. > but never tried trapsess, i.e. I already used trap2sink as ou can see in > debug dump I posted. > > Do you have tried to use snmptrap to see how much duplicates your get in > your network? > I also see zero extra packets with snmptrap, using either net-snmp 5.7.3 or 5.8. An interesting fact is that if I enable IPV6 I get 128 duplicates without > IPV6 I get 64… > Because of this I said that something is really wrong with the NET-SNMP > network code and how > its interpreting the network characteristics where is running. > My example had IPv6 enabled for both TCP and UDP, and I got zero duplicates. > Also with IPV6 enabled I waas unable to use agentaddress clause, with the > 5.7.3 just a message saing that the end point couldnt > be used, with 5.8.dev. the message says that the end point couldn’t be > used because the address (anyone) is in use, what is > not true. > Sounds like there might be something wrong with your network environment. Bill ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users